How do I smooth out the front of the Tau commander thrusters? I'm talking about the new model. You snap the two halves of the jet together and then there is this huge line that runs all the way around the front of it and to the back and into the thrusters even. I'm trying to use liquid green stuff and the results I'm getting are terrible and lumpy. My camera got busted a few months back so I can't get a picture. The liquid green stuff worked fine for the smoothing out the inside of the thrusters, but not front piece that the thrusters are on. I'm not sure how to get that smooth look for them like in GW's page. https://www.games-workshop.com/en-CA/Ta ... ander-2015
6th image and the 360 degrees one and the frontal view shows the front panel of the thrusters to be very smooth (You can just barely make out the center line). Also I tried the liquid green stuff on the front after the fact I realized the two halves were not the same height so I can't even attempt to seal the hole. I guess I should file down the taller half to be the same height as the other? I've never attempted smoothing like this on a model before so I'm lost.