Planning far ahead again... I was pottering around in my workshop/shed doing some cleanup after a DIY job and found an old football table base. It is 5-6mm thick fibreboard and it got me thinking...
When I get around to building up my HW teams I want them to be based so as to be able to remove one of the models as a wound marker. One thing lead to another and these where the result
The discs are a little over 60mm (nearest size of cutter I had) with a 26mm diameter recess drilled out to a depth to fit the standard 25mm plastic base. They have just been painted with a watered down PVA and when dry will get a spray of black primer.
I only made 9 to start off with but I have enough fibre board for at least another 9
If anyone is interested in making their own you will need one of these:
Hole Saw, 65mm Diameter
and one of these:
Kitchen Cupboard Door Hinge Hole Cutter Drill 25/26mm diameter
and naturally a drill with a drill stand
Users browsing this forum: No registered users and 1 guest